Required tools:
11/32” driver
5/16” driver (if needing to replace video card)
#2 Phillip’s screwdriver
Required Parts & hardware:
1 - C020735: BUTTON DECK 10.1” LCD ST42
1 - C030636: HARNESS POWER PDM3 12VDC 48IN
1 – C055708: CABLE DATA USB A to MICRO B 6FT
1 – C030601: DISPLAY HDMI ULTRA SLIM 6FT
1x KIT-40136-U
Parts possibly needed (based upon pre-install inspection):
C055714: PCBA VIDEO TUL GEOFORCE 1050TI 4 PORT
C54-00024: HDMI to DP adapter (to convert game monitor when using only HDMI cable/port-on-card)
C381506: COVER METAL ATLAS LOGIC BOX LID SNGL SLOT VID CARD
** Pre-Install inspection **
Having a video card that is compatible with the LCD button is critical in the success of the operation. To determine if your existing video card is compatible, pre-inspect the cabinets for conversion to see if you need to order a new replacement card if yours are not compatible.
| Warning |
|---|
Rule of thumb: if your existing card has a spare, unused, FULL-SIZED HDMI port; you should be good. Anything else will not be compatible. |
Most up-to-date: C055714 – current used card in stock, and what needs to be ordered to replace a non-compatible card:
conversion Process:
Using an AGS white barrel key (or location’s key if applicable) remove the button deck access door located under the deck.
Unfasten x3 thumb screws (use #2 Phillip’s if overtight)
Using an 11/32 driver, loosen the support clips on each front- corner of the assembly.
Slide Button deck out of frame and lift backside to remove both power and USB comm from PDM board, and remove deck from cabinet.
Remove old PDM power harness from PIOM, and tuck both ends into cable management out of the way.
Install HDMI and USB – A to Micro B cables in Video Card and Logic, and route to button deck area following existing path.
Should have x4 cables in Button Deck area now: 1 – HDMI for deck video, 1 – Micro-USB for deck touch, 1 – existing USB for PDM3 Comm, 1 – 4-pin Molex
Install LCD button deck assembly – Easiest method: With Main door open, start from Right-side of cabinet frame, and work assembly left-and-down (under main door) to seat into place.
Once deck is seated into place, pull forward towards bolster to close the gap between bolster and deck.
Fasten LCD button deck using x3 – thumbscrews.
Connect x4 harnesses: PDM3 power & PDM USB comm, Micro-USB, and deck HDMI.
