Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Part Number C40-00510

The Pax-S Card Shuffler can better handle certain cards with a change to the top brake roller. The standard setup, the top and bottom brake rollers are both aluminum rollers. The optional setup is to replace the top roller with a urethane roller. The bottom roller remains an aluminum roller.

Installation instructions

  • Remove outfeed and infeed trays

  • Remove the two socket head screws attaching the brake roller shaft

  • Remove the shaft and roller assembly

  • Remove the e-ring from one side of the roller

  • Remove aluminum roller, install urethane roller

  • The roller has a one way clutch, position roller so it stops when a card passes

  • If the oval washers are deformed, replace with heavy round washers C40-00470

  • Install shaft and roller assembly with socket head screws and washers

  • Snug screws and back off 1/8 to ΒΌ turn

  • Adjust clearance between top and bottom rollers with two cards.

    • The two card clearance is only for the urethane roller.

  • Press lightly on the top roller and tighten screws. Only a slight amount of drag on the top card is needed for this setup. The clearance should be equal across the entire roller

  • Install trays and test run

...