/
Sweeper Shuffle Position & Home Position

AGS Field Service Knowledge Base

Sweeper Shuffle Position & Home Position

This must be checked on install and anytime the sweeper assembly is removed
If this setting is not set correct it could cause agitation errors


Once the shuffler is turned on push the green and red buttons at the same time for 5 seconds or untill the green and red lights shut off.

Next scroll to the Setup Menu by pressing the green button. At the Setup Menu press the red button.

Next scroll to the Sweeper setup and press the red button.

Next enter the password.

Scroll to the sweeper cycle.

Press the red button to run the sweeper cycle.

When the Sweeper cycle is running check that the sweeper arms stop in the correct position.

If the settng needs to be adjusted go back and adjust shuffle position ( adjusting to a negitive number will move the sweeper arms down ) ( adjusting to a positive number will move the sweeeper arms up ). If adjustment is needed go back and run the sweeper cycle to make sure the shuffle position is stopping in correct position. run the sweeper cycle a few times to verify.

 

Related content

Sweeper / Trap Door Adjustment
Sweeper / Trap Door Adjustment
More like this
DEX Sweeper Assembly Inspection
DEX Sweeper Assembly Inspection
More like this
PAX Field Service and Setup Manual
PAX Field Service and Setup Manual
More like this
DEX ERRORS
More like this
PAX Preparing Shuffler Please Wait Error
PAX Preparing Shuffler Please Wait Error
More like this
Worm Gear Not Moving Smoothly
Worm Gear Not Moving Smoothly
More like this

For assistance email support@playags.com or call 1-877-358-6300