The shuttle will need to be removed to tighten the 4 screws on the bracket to the linear guide.
Remove The Display
Remove the display by loosening the two 2.5mm screws on the top side of the display bracket.
Remove the two 2.5mm screws on the bottom of the display bracket.
Unplug the LED light on the back side of the display.
Slide the display back and unplug the HDMI and USB cables from the display and set the display off to the side.
Remove The Top Plate
Remove the two 2.5mm screws on the back of the shuttle assembly.
Remove the five 2.5mm screws on the top plate.
Unplug the two sensors on the top plate. Lift the top plate up and set it on the side.
Removing The Shuttle
With the shuttle in the down position on the right side of the shuffler on the frame for the shuttle there are access holes remove the four 2mm screws holding the shuttle to the linear guide bracket.
Move the shuttle away from the linear guide and straight up. Set the shuttle to the side.
The shuttle bracket is attached to the belt. Slide the shuttle bracket all the way up to access the four 2mm screws on the bracket. Remove one screw at a time and use a drop of LOCTITE 222 Purple Low Strength Threadlocker on each screw. Reassemble the shuffler and check the insert offset and test the shuffler.
**** LOCTITE IS ONLY USED ON THESE FOUR SCREWS ****
**** ONLY USE LOCTITE 222 Purple Low Strength ****
