AGS Field Service Knowledge Base

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Cause

  1. Insert offset not set or set incorrectly

  2. Guide blocks misaligned

  3. Bad Hall Effect sensor for shuttle homing

  4. Loose shuttle belt tensioner

Solution

  1. In the Machine Control menu adjust offset to align marks

  2. Re-align guide blocks

  3. Replace the bottom hall effect sensor for the shuttle

  4. Recalibrate and tighten shuttle belt tensioner

  • No labels

0 Comments

You are not logged in. Any changes you make will be marked as anonymous. You may want to Log In if you already have an account.
 

For assistance email support@playags.com or call 1-877-358-6300