Please Note Tabletop Left or Right of Dealer Are Ordered Separate from Kit-80014

Open

Open

Install The L Brackets Using The #8X1 Phillips Pan Head Wood Screws Supplied in Hardware Kit Off Table Pax. Make Sure the Two Holes on The L Brackets Are at The Back Side of The Tabletop and The Long and Short L Brackets Are on The Correct Sides Long and Short (See Pic). If Installing Right of Dealer The outer Holes Must Be Used On Tabletop

Leg Kit

1. Screw ½”-13 Thin Hex Nut To ½”-13 Threaded Base

2. Screw The ½”-13 Threaded Base Into The Lower Support Leg.

3. Slide The Lower Support Leg Into The Upper Support Leg

4. The Lower Leg Has Multiple Holes To Adjust To Different Table Hight. Select The Correct Length And Install The ¼ “-20 Hex Head Screw 1- ½ Long Black And ¼ -20 Nylon Locknut Zink

5. Install The Leg To The Longer L Bracket Using the Two ¼ -20 Head ¾  Long Screws And ¼-20 Locknut Black