PAX Ejector Belt Tension

In some cases, the Ejector belt has been set to tight and the belt tension needs to be adjusted.

•  

  Open

  

   

•  

Remove the two 2.5mm screws and clamp holding the belt to the Ejector located at the bottom of the display.

Open

Open

Slide the Ejector back far enough to access the bottom screws on the Ejector motor. Loosen the four 2.5mm screws to the motor to adjust the belt tension. The tension on the belt should not be tight.

Open

Open

Once the tension has been adjusted slide the Ejector back into place and install the clip. There is no adjustment for the clip to belt. On bootup the ejector will home to the correct position.